SAL-VIZZY-1Z - VIZZY WiFi ALARM SYSTEM; 1 ZONE ALARM, NEMA 1 w/9V DC BACKUP (ALARM PANEL ONLY) ALDERON, IND.

(1) Power LED - A green LED illuminates (solid) on the front of the alarm panel to indicate the power is on.

(2) Alarm LED - During an alarm condition, the red alarm LED will illuminate (solid/slow flash) on the front of the alarm panel.

(3) WiFi LED - A blue LED illuminates (slow flash) when a WiFi connection is established and  (solid) when connected to Vizzy.Site™.

(4) Alarm Buzzer - The alarm buzzer will annunciate (solid) in addition to the visual indication provided by the red alarm LED during an alarm condition.

(5) Test/Silence Pushbutton - Press to test the alarm; all LEDs should illuminate (quick flash) and buzzer should annunciate (quick pulse) after approximately 5-6 seconds. During an alarm condition, press to silence the buzzer.

(6) WiFi Connect Pushbutton - Press to select either WPS or HTTP mode and establish a WiFi connection to an IP address.

(7) Sensor Inputs - Connect a field installed sensor to the terminals from the monitoring area.

(8) Auxiliary Contacts - Interface with an external device including BAS systems and phone dialers. The normally open dry contacts can switch 30VDC, 700mA maximum (each).

(9) Battery Backup - Install (3) AA batteries (not included) for battery backup during power outages. The green power LED will illuminate (slow flash) during battery backup mode to conserve battery power.

(10) Panel Access - Pull the cover off to access the panel, includes an open wiring compartment to safely route wires while connecting sensors and auxiliary dry contacts.